Otherwise, spring pressure from the deck lift springs will tend to pull the stop away from the handle. Refer to tire pressure information in the Maintenance section of this manual. The notch located at the rear of the right height adjusting bar is to be used when the deck is placed in the transport mode. When the control levers are in the park brake position the tractor will not move when the engine is on and drive pumps are operating. Jam both nuts against the block.
If not, stop engine immediately and check for the cause. Check fuel line hoses, fuel valve and grommet for any cracks or leaks. Some repairs require the assistance of a trained service mechanic and should not be attempted by unskilled personnel. Correcting the problem as quickly as possible is the best insurance. Raise deck and place 3" of blocking under all 4 corners of the deck Fig.
Hot selection of Virgins' First time sex stories at Tags: Spindles Machine ductile housing. Hustler relay - Quality porn. Do not force lubricant in to grease zerks. Fuel Filter Replaceable, automotive-type. The engine should continue to run.
Never operate the mower deck with discharge chute removed or in raised position. Stens Starter Solenoid. This will assure that the height will not move during the setting process. Continue at an angle until the wheel clears and then pivot the opposite wheel around. Check oil filler cap and fuel tank cap to make certain they are securely in place. The units control levers are very responsive: